よくある質問当社の製品とソリューションに関するよくある質問

ご質問はこちらご質問はこちら

All FAQs (1969 total: showing 1561-1580)

Is there a way to check when the last background calibration was executed on a CR1000?
When will a data logger reset the switched 12 V channel (SW12)?
What is the TDF file?
What does the “Warning: Internal data storage memory was reinitialized” message mean?
How are raw readings produced from half-bridge measurements different between data loggers?
Where can processor usage information be found?
What is a skipped system scan?
Why do the PPPOpen and PPPClose commands run so frequently?
Can a data logger be used for logging binary data and hexadecimal data?
データロガーがシリアルセンサからデータを収集している間に、LoggerNet RTMC を使用することは可能ですか?
How long can the cables be between networked data loggers?
Can two of the same sensor be wired to the same COM port on a data logger, with each sensor sending separate data files to the data logger?
Using RTMC Pro, is there a way to set up email alerts for a complete data logger failure?
データロガーを GPS 時間と同期させるために使用できる GPS インターフェイスはありますか?
If an RF modem is used to communicate with a data logger and a PC running LoggerNet, but the modem baud rate is one third of the data logger baud rate, is that a problem?
Why might a data logger refuse having a file uploaded to it?
Is there a free software package that allows the generation of programs that can sample data on the RS-232 or COM port of the data logger?
If a data logger OS has not been upgraded in a long time, can the most current OS be downloaded, or do the upgrades need to be done incrementally?
Can two data loggers be connected over the RS-232 port, or do they need to use the COM ports to connect?
How often is the lithium battery voltage measured by the data logger?

戻る次へ

CAMPBELL SCIENTIFIC JAPAN

country map

会社名	キャンベル・サイエンティフィック・ジャパン株式会社

ウェブサイトフィードバックウェブサイトフィードバック © 2026 Campbell Scientific Japan