よくある質問当社の製品とソリューションに関するよくある質問

ご質問はこちらご質問はこちら

All FAQs (1994 total: showing 1741-1760)

Is it possible to connect a fiber optic line directly to the RS-232 interface on the CR800 or the CR850?
Will a program written for the CR1000 work on a CR800 or CR850?
Is using Ethernet the best option to connect a CR800 to a PC that is 500 to 700 feet away?
How many SDI sensors can the CR800 or CR850 handle?
If a data logger is accidentally plugged into a 24 Vdc power source, what can be done to correct the situation?
For redundancy purposes, is it possible to have two GSM modems connected to a CR800 or CR850 with each modem on a different cellular provider?
What software is necessary to modify a program built with LoggerNet for an isolated CR800 or CR850?
How can multiple programs for different sensors be sent to a single CR800 or CR850 datalogger?
Can the CR800 be programmed through either a mountable or portable keyboard display?
CR800 または CR850 で使用できるイーサネットモジュールはありますか?
Do the CR200X and CR800 use the same PakBus protocol or a different PakBus protocol?
What is the maximum current that the control port of a CR800, CR850, or CR1000 can source without causing damage?
Does the CR800 or CR850 work with a 2 kHz (maximum) burst mode for the VoltDiff() instruction like the CR1000 does?
Can the battery on the CR800 or CR850 be changed by the user?
How can several SDI-12 instruments be wired to a single data logger terminal?
Can a CR800 wiring panel be used on a data logger other than the original data logger?
What is the maximum supply voltage of a CR800 or CR850 without damaging the data logger?
Is there a device similar to the ACL1 that can handle a 20 to 30 Vac or Vdc input?
Is there a device similar to the ACL1 that has multiple inputs/outputs?
Why do the example programs for the WXT520 use a scan rate of 5 seconds?

戻る次へ

CAMPBELL SCIENTIFIC JAPAN

country map

会社名	キャンベル・サイエンティフィック・ジャパン株式会社

ウェブサイトフィードバックウェブサイトフィードバック © 2026 Campbell Scientific Japan